Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual

Page 699

Advertising
background image

686

Brocade Mobility RFS Controller CLI Reference Guide

53-1003098-01

7

radio-share-mode Configure the radio-share mode of operation for

this radio

rate-selection Default or Opportunistic rate selection

remove-override Negate a command or set its defaults

rf-mode Configure the rf-mode of operation for this radio

rifs Configure Reduced Interframe Spacing (RIFS)

parameters

rts-threshold Configure the RTS threshold

shutdown Shutdown the selected radio interface

sniffer-redirect Capture packets and redirect to an IP address

running a packet capture/analysis tool

stbc Configure Space-Time Block Coding (STBC) parameters

use Set setting to use

wireless-client Configure wireless client related parameters

wlan Enable wlans on this radio

clrscr Clears the display screen

commit Commit all changes made in this session

do Run commands from Exec mode

end End current mode and change to EXEC mode

exit End current mode and down to previous mode

help Description of the interactive help system

revert Revert changes

service Service Commands

show Show running system information

write Write running configuration to memory or terminal

rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#

The following table summarizes the radio interface configuration commands.

Commands

Description

Reference

aeroscout

Enables Aeroscout multicast packet forwarding

page 7-687

aggregation

Configures 802.11n aggregation parameters

page 688

airtime-fairness

Enables fair access for clients based on airtime usage

page 690

antenna-diversity

Transmits antenna diversity for non-11n transmit rates

page 691

antenna-downtilt

Enables Advanced Element Panel Technology (ADEPT) antenna mode

page 691

antenna-gain

Specifies the antenna gain for the selected radio

page 692

antenna-mode

Configures the radio antenna mode

page 693

beacon

Configures beacon parameters

page 694

channel

Configures a radio’s channel of operation

page 695

data-rates

Specifies the 802.11 rates supported on a radio

page 696

description

Configures the selected radio’s description

page 700

dfs-rehome

Reverts to configured home channel once Dynamic Frequency Selection (DFS)
evacuation period expires

page 701

dynamic-chain-selecti
on

Enables automatic antenna mode selection

page 702

ekahau

Enables Ekahau multicast packet forwarding

page 702

extended-range

Configures extended range

page 703

guard-interval

Configures the 802.11n guard interval

page 704

Advertising