Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 291)

Brocade Mobility RFS Controller CLI Reference Guide 275
53-1003098-01
4
preferred-controller-group Controller group this system will
prefer for adoption
preferred-tunnel-controller Tunnel Controller Name this system
will prefer for tunneling extended
vlan traffic
radius Configure device-level radius
authentication parameters
rf-domain-manager RF Domain Manager
router Dynamic routing
spanning-tree Spanning tree
tunnel-controller Tunnel Controller group this
controller belongs to
use Set setting to use
vrrp VRRP configuration
wep-shared-key-auth Enable support for 802.11 WEP
shared key authentication
clrscr Clears the display screen
commit Commit all changes made in this
session
do Run commands from Exec mode
end End current mode and change to EXEC
mode
exit End current mode and down to
previous mode
help Description of the interactive help
system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to
memory or terminal
rfs4000-229D58(config-profile-de)#
rfs7000-37FABE(config-profile-default-rfs7000)#
nx4500-5CFA2B(config-profile-test)#?
Profile Mode commands:
adopter-auto-provisioning-policy-lookup Use centralized auto-provisioning
policy when adopted by another
controller
alias Alias
area Set name of area where the system
is located
arp Address Resolution Protocol (ARP)
auto-learn-staging-config Enable learning network
configuration of the devices that
come for adoption
autogen-uniqueid Autogenerate a unique id
autoinstall Autoinstall settings
bridge Ethernet bridge
captive-portal Captive portal
cdp Cisco Discovery Protocol
cluster Cluster configuration
configuration-persistence Enable persistence of configuration
across reloads (startup config
file)
controller WLAN controller configuration
critical-resource Critical Resource