Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 31)

12 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
1
When logging into the controller for the first time, you are prompted to change the password.
To change user credentials:
1. Enter the username, password, role and access details.
rfs7000-37FABE(config-management-policy-default)#user testuser password
admin123
role helpdesk access all
rfs7000-37FABE(config-management-policy-default)# commit
rfs7000-37FABE(config-management-policy-default)#show context
management-policy default
telnet
http server
https server
ssh
user admin password 1
ba7da2bf2f7945af1d3ae1b8b762b541bd5bac1f80a54cd4488f38ed44b91ecd role
superuser access all
user operator password 1
0be97e9e30d29dfc4733e7c5f74a7be54570c2450e855cea1a696b0558a40401 role monitor
access all
user testuser password 1
bca381b5b93cddb0c209e1da8a9d387fa09bfae14cc987438a4d144cb516ffcb role
helpdesk access all
snmp-server community public ro
snmp-server community private rw
snmp-server user snmptrap v3 encrypted des auth md5 0
snmp-server user snmpoperator v3 encrypted des auth md5 0 operator
snmp-server user snmpmanager v3 encrypted des auth md5 0
rfs7000-37FABE(config-management-policy-default)#
2. Logon to the Telnet console and provide the user details configured in the previous step to
access the controller.
rfs7000 release 5.5.0.0-018D
rfs7000-37FABE login: testuser
Password:
Welcome to CLI
Starting CLI...
rfs7000-37FABE>
Configuring SSH
By default, SSH is enabled from the factory settings on the controller. The controller requires an IP
address and login credentials.
To enable SSH access in the default profile, login through the serial console. Perform the following:
1. Access the GLOBAL CONFIG mode from the PRIV EXEC mode.
rfs7000-37FABE> en
rfs7000-37FABE# configure
Enter configuration commands, one per line. End with CNTL/Z.
2. Go to ‘default-management-policy’ mode.
rfs7000-37FABE(config)# management-policy default
rfs7000-37FABE(config-management-policy-default)#
3. Enter SSH at the command prompt.
rfs7000-37FABE(config-management-policy-default)# ssh