Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 640)

Brocade Mobility RFS Controller CLI Reference Guide 627
53-1003098-01
7
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no [local-endpoint-ip|mode|peer|security-association|session-key|use]
Parameters
no [local-endpoint-ip|mode|peer|security-association|session-key|use]
Example
rfs7000-37FABE(config-profile-default-rfs7000-cryptomap-map1#1)#show context
crypto map map1 1 ipsec-manual
use ip-access-list test
peer 172.16.10.12
mode transport
session-key inbound esp 273 0 cipher esp-null authenticator sha 5876897
rfs7000-37FABE(config-profile-default-rfs7000-cryptomap-map1#1)#
rfs7000-37FABE(config-profile-default-rfs7000-cryptomap-map1#1)#no use
ip-access-list
rfs7000-37FABE(config-profile-default-rfs7000-cryptomap-map1#1)#no peer
rfs7000-37FABE(config-profile-default-rfs7000-cryptomap-map1#1)#no mode
rfs7000-37FABE(config-profile-default-rfs7000-cryptomap-map1#1)#show context
crypto map map1 1 ipsec-manual
session-key inbound esp 273 0 cipher esp-null authenticator sha 58768979
rfs7000-37FABE(config-profile-default-rfs7000-cryptomap-map1#1)#
crypto-remote-vpn-client commands
crypto
This section documents the IKEV2 remote VPN client configuration settings. Use this command to
define the server resources used to secure (authenticate) a remote VPN connection with a target
peer.
Use the profile-config instance to configure remote VPN client settings. To navigate to the
remote-vpn-client configuration instance, use the following commands:
<DEVICE>(config)#profile <DEVICE-TYPE> <PROFILE-NAME>
<DEVICE>(config-profile-<PROFILE-NAME>)#crypto remote-vpn-client
<DEVICE>(config-profile-<PROFILE-NAME>-crypto-ikev2-remote-vpn-client)#
no local-endpoint-ip Deletes the local IP address
no mode Resets the tunnelling mode to default (Tunnel)
no peer Deletes the remote peer settings
no security-association Deletes the security association parameters
no session-key Deletes the session key parameters
no use Resets the IP access list parameters values