Static-binding-mode commands – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 972
Brocade Mobility RFS Controller CLI Reference Guide
961
53-1003098-01
13
Related Commands:
static-binding-mode commands
The following table summarizes static binding configuration mode commands.
bootfile
The Bootfile command provides a diskless node the path to the image file used while booting up.
Only one file can be configured for each static IP binding.
For more information on the BOOTP protocol with reference to static binding, see
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
bootfile <IMAGE-FILE-PATH>
Resets values or disables the DHCP policy static binding settings
Invokes static binding configuration commands
Command
Description
Reference
Assigns a Bootfile name for the DHCP configuration on the network pool
Configures a client name
Configures default router or gateway IP address
Sets the DNS server’s IP address available to all DHCP clients connected to the DHCP
pool
Sets the network pool’s domain name
Configures a host’s fixed IP address
Configures a NetBIOS (WINS) name server IP address
Defines the NetBIOS node type
Specifies the next server used in the boot process
Negates a command or sets its default
Configures raw DHCP options
Sends a DHCP offer and DHCP Ack as unicast messages
Adds static routes installed on DHCP clients