Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 373)

Brocade Mobility RFS Controller CLI Reference Guide 357
53-1003098-01
4
Keep in mind IP and non-IP traffic on the same layer 2 interface can be filtered by applying both an
IP ACL and a MAC ACL to the interface.
Example
rfs7000-37FABE(config-wlan-test)#use aaa-policy test
rfs7000-37FABE(config-wlan-test)#use association-acl-policy test
rfs7000-37FABE(config-wlan-test)#show context
wlan test
ssid testWLAN1
bridging-mode local
encryption-type none
authentication-type none
protected-mgmt-frames mandatory
radius vlan-assignment
time-based-access days weekdays start 10:00 end 16:30
motorola-extensions wmm-load-information
client-load-balancing probe-req-intvl 5ghz 5
client-load-balancing band-discovery-intvl 2
use aaa-policy test
use association-acl-policy test
acl exceed-rate wireless-client-denied-traffic 20 disassociate
proxy-arp-mode strict
broadcast-dhcp validate-offer
shutdown on-unadoption
http-analyze controller
rfs7000-37FABE(config-wlan-test)#
vlan
wlan-mode commands
Sets the VLAN where traffic from a WLAN is mapped
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
vlan [<1-4094>|<VLAN-ALIAS-NAME>]
Parameters