Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 656)

Brocade Mobility RFS Controller CLI Reference Guide 643
53-1003098-01
7
Related Commands:
floor
Profile Config Commands
Sets the floor name where the system is located
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
floor <WORD> {<1-4094>}
Parameters
floor <WORD> {<1-4094>}
Example
rfs7000-37FABE(config-profile-default-rfs7000)#floor fifth
rfs7000-37FABE(config-profile-default-rfs7000)#
rfs7000-37FABE(config-profile-default-rfs7000)#show context
profile rfs7000 default-rfs7000
bridge vlan 1
ip igmp snooping
ip igmp snooping querier
area Ecospace
floor fifth
autoinstall configuration
autoinstall firmware
--More--
rfs7000-37FABE(config-profile-default-rfs7000)#
Related Commands:
no Disables export of startup.log file
floor <WORD>
{<1-4094>} Sets the floor name where the system is located
•
<WORD> – Specify the floor name.
•
<1-4094> – Optional. Configures the floor number from 1 - 4094.
no Resets the configured floor name and number