Wep128 – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 375
Brocade Mobility RFS Controller CLI Reference Guide
359
53-1003098-01
4
Parameters
vlan-pool-member <WORD> {limit <0-8192>}
Example
rfs7000-37FABE(config-wlan-test)#vlan-pool-member 1-10 limit 1
rfs7000-37FABE(config-wlan-test)#show context
wlan test
ssid testWLAN1
vlan-pool-member 1 limit 1
vlan-pool-member 2 limit 1
vlan-pool-member 3 limit 1
vlan-pool-member 4 limit 1
vlan-pool-member 5 limit 1
vlan-pool-member 6 limit 1
vlan-pool-member 7 limit 1
vlan-pool-member 8 limit 1
vlan-pool-member 9 limit 1
vlan-pool-member 10 limit 1
bridging-mode local
encryption-type none
authentication-type none
protected-mgmt-frames mandatory
radius vlan-assignment
time-based-access days weekdays start 10:00 end 16:30
motorola-extensions wmm-load-information
--More--
rfs7000-37FABE(config-wlan-test)#
wep128
Configures WEP128 parameters
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
wep128 [key|keys-from-passkey|transmit-key]
wep128 key <1-4> [ascii|hex] [0 <WORD>|2 <WORD>|<WORD>]
vlan-pool-member
Adds a member VLAN to a WLAN’s VLAN pool
<WORD>
Define the VLANs available to this WLAN. It is either a single index, or a list of VLAN IDs (for example, 1,3,7),
or a range (for example, 1-10)
limit <0-8192>
Optional. Is ignored if the number of clients are limited and well within the limits of the DHCP pool on the
VLAN
•
<0-8192> – Specifies the number of users allowed