Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1168
1160
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
21
The following table summarizes WIPS policy signature configuration mode commands.
bssid
Configures a BSSID MAC address with this WIPS signature for matching
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
bssid <MAC>
Parameters
Commands
Description
Reference
Configures the BSSID MAC address
Configures the destination MAC address
Configures the filter ageout interval
Configures the frame type used for matching
Configures this WIPS policy signature as the Smart RF interference source
Enables or disables the signature mode
Configures payload settings
Configures the source MAC address
Configures a match based on SSID
Configures the wireless client threshold limit
Configures the radio threshold limit
Negates a command or sets its default
Clears the display screen
Commits (saves) changes made in the current session
Ends and exits the current mode and moves to the PRIV EXEC mode
Ends the current mode and moves to the previous mode
Displays the interactive help system
Reverts changes to their last saved configuration
Invokes service commands to troubleshoot or debug
(config-if)
instance
configurations
Displays running system information
Writes information to memory or terminal