Terminate – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 895
Brocade Mobility RFS Controller CLI Reference Guide
883
53-1003098-01
10
Related Commands:
terminate
Adds a device to a device termination list. Devices on this list cannot access the network.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
terminate <MAC>
Parameters
terminate <MAC>
Example
rfs7000-37FABE(config-advanced-wips-policy-test)#terminate 00-40-96-B0-BA-2D
rfs7000-37FABE(config-advanced-wips-policy-test)#show context
advanced-wips-policy test
terminate 00-40-96-B0-BA-2D
server-listen-port 1009
no event dos-cts-flood trigger-against
event dos-cts-flood threshold cts-frames-ratio 8
no event dos-eapol-logoff-storm trigger-against
event dos-eapol-logoff-storm threshold eapol-start-frames-mu 99
rfs7000-37FABE(config-advanced-wips-policy-test)#
Related Commands:
use
Uses an existing device categorization list with the advanced WIPS policy. A device configuration list
must exist before it can be used with the advanced WIPS policy.
Resets local WIPS server’s listening port to default
terminate <MAC>
Adds a device’s MAC address to the device termination list. Devices on this list cannot access the network.
•
<MAC> – Specify the device’s MAC address.
Device’s added to the termination list (identified by their MAC addresses) are removed from connection
within the managed network. Therefore, be sure they represent potential threats.
Removes a device from the device termination list