Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 786)

Brocade Mobility RFS Controller CLI Reference Guide 773
53-1003098-01
7
mint tunnel-controller-load-balancing level1
Parameters
mint dis [priority-adjustment <-255-255>|strict-evis-reachability]
mint level 1 area-id <1-16777215>
mint link force ip <IP> [<1-65535> level 2|level 2] {adjacency-hold-time
<2-600>|
cost <1-10000>|hello-interval <1-120>|ipsec-security {gw}}
mint link [listen ip <IP>|vlan <1-4094>] {adjacency-hold-time <2-600>|cost
<1-10000>|
hello-interval <1-120>|level [1|2]|ipsec-security {gw}}
dis priority-adjustment
<-255-255> Sets the relative priority for the router to become DIS (designated router)
•
priority-adjustment – Sets priority adjustment added to base priority
•
<-255-255> – Specify a value from -255 - 255. The default is 0.
Higher numbers result in higher priorities
strict-evis-reachability Enables reaching EVIS election winners through MiNT
level 1 Configures local MiNT routing settings
•
1 – Configures local MiNT routing level
area-id <1-16777215> Specifies the routing area identifier
•
<1-16777215> – Specify a value from 1 - 16777215.
link force Creates a MiNT routing link
•
force – Forces a MiNT routing link to be created even if not necessary
ip <IP> Creates a MiNT tunnel over UDP/IP
•
<IP> – Specify peer’s IP address
<1-65535> level 2 Specifies a peer’s UDP port to link with the specified IP address
•
level – Specifies routing level
•
2 – Configures inter-site MiNT routing level
adjacent-hold-time
<2-600> Optional. Specifies the adjacency lifetime after hello packets cease
•
<2-600> – Specify a value from 2 - 600 seconds.
cost <1-100000> Optional. Specifies the link cost in arbitrary units
•
<1-100000> – Specify a value from 1 - 100000.
hello-interval <1-120> Optional. Specifies the hello-interval between packets
•
<1-120> – Specify a value from 1 - 120 seconds.
ipsec-security {gw} Optional. Configures the IPSec security gateway
link listen
ip <IP> Creates a MiNT routing link
•
listen – Creates a MiNT listening link
•
ip – Creates a MiNT listening link over UDP/IP
•
<IP> – Specify the IP address of the listening port.
vlan <1-4094> Enables MiNT routing on VLAN
•
<1-4094> – Select VLAN ID from 1 - 4094.
adjacent-hold-time
<2-600> Optional. Specifies the adjacency lifetime after hello packets cease
•
<2-600> – Specify a value from 2 - 600 seconds.