Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 736)

Brocade Mobility RFS Controller CLI Reference Guide 723
53-1003098-01
7
Related Commands:
remove-override
interface-config-radio-instance
Removes the radio’s channel of operation
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
remove-override channel
Parameters
remove-override channel
Example
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-radio1)#show
context
interface radio1
channel 9
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-radio1)#
rfs4000-229D58(config-profile-testBrocade Mobility
RFS4000-if-radio1)#remove-override channel
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-radio1)#
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-radio1)#show
context
interface radio1
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-radio1)#
rf-mode
interface-config-radio-instance
Configures the radio’s RF mode of operation
This command sets the mode to either 2.4 GHz WLAN or 5.0 GHz WLAN support depending on the
radio’s intended client support. If you are currently licensed to use 4.9 GHz, configure the 4.9
GHz-WLAN option.
Set the mode to sensor if using the radio for rogue device detection. The radio cannot support
rogue detection when one of the other radios is functioning as a WIPS sensor. To set a radio as a
detector, disable sensor support on the other access point radio.
Supported in the following platforms:
no Resets the rate selection mode to standard (monotonic)
remove-override channel Removes the radio’s channel of operation