Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 762)

Brocade Mobility RFS Controller CLI Reference Guide 749
53-1003098-01
7
interface ge2
ip dhcp trust
qos trust dscp
qos trust 802.1p
interface ge3
ip dhcp trust
qos trust dscp
qos trust 802.1p
interface ge4
ip dhcp trust
qos trust dscp
qos trust 802.1p
interface pppoe1
use firewall-policy default
ip dns-server-forward
ip nat inside source list test interface vlan1 pool pool1 overload
service pm sys-restart
router ospf
rfs7000-37FABE(config-profile-default-rfs7000)#
rfs7000-37FABE(config-profile-default-rfs7000-nat-pool-pool1)#?
Nat Policy Mode commands:
address Specify addresses for the nat pool
no Negate a command or set its defaults
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile-default-rfs7000-nat-pool-pool1)
Related Commands:
nat-pool-config-instance
ip
Use the config-profile-<DEVICE-PROFILE-NAME> instance to configure Network Address Translation
(NAT) pool settings.
<DEVICE>(config-profile-default-<PROFILE-NAME>)#ip nat pool pool1
The following example uses the config-profile-default-rfs7000 instance to configure NAT pool
settings:
<DEVICE>(config-profile-default-<PROFILE-NAME>)#ip nat pool pool1
rfs7000-37FABE(config-profile-default-rfs7000)#ip nat pool pool1
rfs7000-37FABE(config-profile-default-rfs7000-nat-pool-pool1)#ip nat pool
pool1
no Disables or reverts settings to their default