Memberof, Mu-mac – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1122
1114
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
19
memberOf
Applies an Active Directory (AD) group filter to this user-defined role. A wireless client can be a
member of more than one group within the AD database. This command applies a AD group based
firewall, which applies a role to a wireless client only if it belongs to the specified AD group.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
memberOf <AD-GROUP-NAME>
Parameters
memberOf <AD-GROUP-NAME>
Example
rfs4000-229D58(config-role-policy-test-user-role-test)#memberOf ADTestgroup
rfs4000-229D58(config-role-policy-test-user-role-test)#
rfs4000-229D58(config-role-policy-test-user-role-test)#show context
user-role test precedence 1
assign vlan 1
assign rate-limit to-client 200
memberOf ADTestgroup
rfs4000-229D58(config-role-policy-test-user-role-test)#
Related Commands:
mu-mac
Configures a MAC address and mask based filter for this role policy
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
memberOf
<AD-GROUP-NAME>
Applies this user-defined role to a client only if the client belongs to the specified AD group
•
<AD-GROUP-NAME> – Specify the AD group name.
Removes the AD group assigned to this user-defined role