Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 494
480
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
6
l2tpv3 {on <DEVICE-NAME>}
l2tpv3 {tunnel <L2TPV3-TUNNEL-NAME>} {session <L2TPV3-SESSION-NAME>}
{(on <DEVICE-NAME>)}
l2tpv3 {tunnel-summary} {on <DEVICE-NAME>}
l2tpv3 {tunnel-summary} {down|up} {on <DEVICE-NAME>}
Example
ap7131-11E6C4#show l2tpv3 tunnel-summary
-----------------------------------------------------------------------------
----------
Sl No Tunnel Name Tunnel State Estd/Total Sessions
Encapsulation Protocol
-----------------------------------------------------------------------------
----------
1 testTunnel Established (secured by ipsec) 1/1 IP
Total Number of Tunnels 1
ap7131-11E6C4#
ap7131-11E6C4#show l2tpv3
-----------------------------------------------------------------------------
--
Tunnel Name : testTunnel
l2tpv3
{on <DEVICE-NAME>}
Displays a L2TPv3 tunnel and session details or summary
•
on <DEVICE-NAME> – Optional. Displays L2TPv3 information on a specified access point or wireless
controller
•
<DEVICE-NAME> – Specify the name of AP, wireless controller, or service platform.
l2tpv3
Displays a L2TPv3 tunnel and session details or summary
tunnel
<L2TPV3-TUNNEL-NAME>
Optional. Displays a specified L2TPv3 tunnel information
•
<L2TPV3-TUNNEL-NAME> – Specify the L2TPv3 tunnel name.
session
<L2TPV3-SESSION-NAME>
Optional. Displays a specified L2TPv3 tunnel session information
•
<L2TPV3-SESSION-NAME> – Specify the session name.
on <DEVICE-NAME>
The following keyword is recursive and common to the ‘session <L2TPV3-SESSION-NAME>’ parameter.
•
on <DEVICE-NAME> – Optional. Displays a L2TPv3 tunnel and session details, based on the
parameters passed, on a specified device.
•
<DEVICE-NAME> – Specify the name of AP, wireless controller, or service platform.
l2tpv3
Displays L2TPv3 tunnel and session details or summary
For an L2TPv3 tunnel over Auto IPSec, the tunnel status is displayed as: Established (secured by ipsec)
tunnel-summary
{on <DEVICE-NAME>}
Optional. Displays L2TPv3 tunnel summary
•
on <DEVICE-NAME> – Optional. Displays a L2TPv3 tunnel summary on a specified device
•
<DEVICE-NAME> – Specify the name of AP, wireless controller, or service platform.
l2tpv3
Displays a L2TPv3 tunnel and session details or summary
tunnel-summary
Optional. Displays a L2TPv3 tunnel summary, based on the parameters passed
down
Optional. Displays un-established tunnels summary
up
Optional. Displays established tunnels summary
on <DEVICE-NAME>
The following keyword is common to the ‘down’ and ‘up’ parameters:
•
on <DEVICE-NAME> – Optional. Displays summary, for un-established or established tunnels, on a
specified device
•
<DEVICE-NAME> – Specify the name of AP, wireless controller, or service platform.