Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 838)

Brocade Mobility RFS Controller CLI Reference Guide 825
53-1003098-01
7
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
remove-override <PARAMETERS>
Parameters
None
Example
rfs4000-229D58(config-device-00-23-68-22-9D-58)#remove-override ?
adopter-auto-provisioning-policy-lookup Use centralized auto-provisioning
policy when adopted by another
controller
alias Alias
all Remove all overrides for the device
area Reset name of area where the system is
located
arp Address Resolution Protocol (ARP)
auto-learn-staging-config Enable learning network
configuration
of the devices that come for adoption
autoinstall Autoinstall settings
bridge Bridge group commands
captive-portal Captive portal
cdp Cisco Discovery Protocol
channel-list Configure a channel list to be
advertised to wireless clients
cluster Cluster configuration
configuration-persistence Automatic write of startup
configuration file
contact The contact
controller WLAN controller configuration
country-code The country of operation
critical-resource Critical Resource
crypto Encryption related commands
device-upgrade Device firmware upgrade
dot1x 802.1X
dscp-mapping IP DSCP to 802.1p priority mapping for
untagged frames
email-notification Email notification configuration
enforce-version Check the firmware versions of
devices
before interoperating
environmental-sensor Environmental Sensors Configuration
events System event messages
export Export a file
firewall Enable/Disable firewall
floor Reset name of floor where the system
is located
global Remove global overrides for the device
but keeps per-interface overrides