Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1187)

Brocade Mobility RFS Controller CLI Reference Guide 1179
53-1003098-01
22
no wmm [backgorund|best-effort|video|voice] [aifsn|cw-max|cw-min|txop-limit]
Parameters
no [accelerated-multicast [<IP>|autodetect]|classification
{non-unicast|non-wmm}|
multicast-mask [primary|secondary]|qos trust [dscp|wmm]|svp-prioritization|
voice-prioritization]
no rate-limit [client|wlan] [from-air|to-air] {max-burst-size|rate|
red-threshold [background|best-effort|video|voice]}
no wmm [power-save|qbss-load-element]
no accelerated-multicast
[<IP>|autodetect] Disables accelerated multicast streams and forwarding QoS classification
•
<IP> – Removes specified IP address. Specify the IP address
•
autodetect – Disables multicast streams automatic detection
no classification
[non-unicast|
non-wmm] Disables WLAN classification scheme
•
non-unicast – Optional. Removes multicast and broadcast packet classification
•
non-wmm – Optional. Removes non-WMM client traffic classification
no multicast-mask
[primary|secondary] Disables the egress prioritization primary or secondary multicast mask
•
primary – Removes the first egress multicast mask
•
secondary – Removes the second egress multicast mask
no qos trust [disquiet] Disables the QoS service
•
trust – Ignores the trust QOS values of ingressing packets
•
dscp – Ignores the IP DSCP values of ingressing packets
•
wmm – Ignores the 802.11 WMM QoS values of ingressing packets
no svp-prioritization Disables Spectralink Voice Protocol (SVP) support on a WLAN
no voice-prioritization Disables voice client priority over other clients (applies to non-WMM clients)
no rate-limit [client|wlan] Disables traffic rate limit parameters
•
Disables client traffic rate limits
•
Disables WLAN traffic rate limits
[from-air|to-air] The following are common to the client and WLAN parameters:
•
from-air – Removes client/WLAN traffic rate limits in the up link direction. This is traffic from the
wireless client to the network
•
to-air – Removes client/WLAN traffic rate limits in the down link direction. This is traffic from the
network to the wireless client
max-burst-size Optional. Disables the maximum burst size value
rate Optional. Disables the traffic rates configured for a wireless client or WLAN
red-threshold Optional. Disables random early detection threshold values configured for the traffic class
•
background – Disables the low priority traffic (background) threshold value
•
best-effort – Disables the normal priority traffic (best effort) threshold value
•
video – Disables the video traffic threshold value
•
voice – Disables the voice traffic threshold value
no wmm Disables 802.11e/wireless multimedia parameters
power-save Disables support for WMM-Powersave (U-APSD)
qbss-load-element Disables support for the QBSS load information element in beacons and probe responses