Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 973)

962 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
13
Parameters
bootfile <IMAGE-FILE-PATH>
Example
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1-binding-test)#bootfile
test.txt
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1-binding-test)#show context
static-binding client-identifier test
bootfile test.txt
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1-binding-test)#
Related Commands:
client-name
static-binding-mode commands
Configures the client’s name
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
client-name <NAME>
Parameters
client-name <NAME>
Example
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1-binding-test)#client-name
RFID
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1-binding-test)#show context
static-binding client-identifier test
client-name RFID
bootfile test.txt
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1-binding-test)#
<IMAGE-FILE-PATH> Sets the path to the boot image for BOOTP clients. The file name can contain letters, numbers, dots and
hyphens. Consecutive dots and hyphens are not permitted.
no Resets values or disables DHCP pool static binding settings
bootp Configures BOOTP protocol parameters
<NAME> Specify the name of the client using this static IP address host pool. Do not include the domain name.