Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 636)

Brocade Mobility RFS Controller CLI Reference Guide 623
53-1003098-01
7
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
mode [transport|tunnel]
Parameters
mode [transport|tunnel]
Example
rfs7000-37FABE(config-profile-default-rfs7000-cryptomap-map1#1)#mode
transport
rfs7000-37FABE(config-profile-default-rfs7000-cryptomap-map1#1)#show context
crypto map map1 1 ipsec-manual
mode transport
rfs7000-37FABE(config-profile-default-rfs7000-cryptomap-map1#1)#
peer
crypto-map-ipsec-manual-instance
Sets the peer device’s IP address. This can be set for multiple remote peers. The remote peer can
be an IP address.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
peer <IP>
Parameters
peer <IP>
Example
rfs7000-37FABE(config-profile-default-rfs7000-cryptomap-map1#1)#peer
172.16.10.12
rfs7000-37FABE(config-profile-default-rfs7000-cryptomap-map1#1)#show context
crypto map map1 1 ipsec-manual
peer 172.16.10.12
mode [transport|tunnel] Sets the mode of the tunnels for this crypto map
•
transport – Initiates transport mode
•
tunnel – Initiates tunnel mode (default setting)
peer <IP> Enter the peer device’s IP address. If not configured, it implies respond to any peer.