Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 852)

Brocade Mobility RFS Controller CLI Reference Guide 839
53-1003098-01
8
• Service Platforms — Brocade Mobility RFS9510
Syntax:
authentication [eap|protocol|server]
authentication eap wireless-client [attempts
<1-10>|identity-request-retry-timeout
<10-5000>|identity-request-timeout <1-60>|retry-timeout-factor
<50-200>|
timeout <1-60>]
authentication protocol [chap|mschap|mschapv2|pap]
authentication server <1-6> [dscp|host|nac|nai-routing|onboard|proxy-mode|
retry-timeout-factor|timeout]
authentication server <1-6> dscp <0-63>
authentication server <1-6> host <IP/HOSTNAME> secret [0 <SECRET>|2
<SECRET>|<SECRET>]
{port <1-65535>}
authentication server <1-6> nac
authentication server <1-6> nai-routing realm-type [prefix|suffix] realm
<REALM-NAME>
{strip}
authentication server <1-6> onboard [controller|self]
authentication server <1-6> proxy-mode
[none|through-controller|through-mint-host
<HOSTNAME/MINT-ID>|through-rf-domain-manager]
authentication server <1-6> retry-timeout-factor <50-200>
authentication server <1-6> timeout <1-60> {attempts <1-10>}
Parameters
authentication eap wireless-client [attempts
<1-10>|identity-request-retry-timeout
<10-5000>|identity-request-timeout <1-60>|retry-timeout-factor <50-200>|
timeout <1-60>]
eap Configures EAP authentication parameters
wireless-client Configures wireless client’s EAP parameters
attempts <1-10> Configures the maximum number of attempts allowed to authenticate a wireless client
•
<1-10> – Specify a value from 1 - 10. The default is 3.
identity-request-retry-timeo
ut <10-5000> Configures the interval, in milliseconds, after which an EAP-identity request to the wireless client is retried
•
<10-5000> – Specify a value from 10 - 5000 milliseconds.
identity-request-timeout
<1-60> Configures the timeout, in seconds, after the last EAP-identity request message retry attempt (to allow time
to manually enter user credentials)
•
<1-60> – Specify a value from 1 - 60 seconds. The default is 3 seconds.