Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1274)

1266 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
27
rfs7000-37FABE(config-meshpoint-test)#?
Mesh Point Mode commands:
allowed-vlans Set the allowed VLANs
beacon-format The beacon format of this meshpoint
control-vlan VLAN for meshpoint control traffic
data-rates Specify the 802.11 rates to be supported on this meshpoint
description Configure a description of the usage of this meshpoint
meshid Configure the Service Set Identifier for this meshpoint
neighbor Configure neighbor specific parameters
no Negate a command or set its defaults
root Set this meshpoint as root
security-mode The security mode of this meshpoint
shutdown Shutdown this meshpoint
use Set setting to use
wpa2 Modify ccmp wpa2 related parameters
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-meshpoint-test)#
The following table summarizes meshpoint configuration commands.
TABLE 25 Meshpoint-Config commands
Command Description Reference
allowed-vlans Configures VLANs allowed on the meshpoint page 1267
beacon-format Configures the beacon format for the meshpoint AP page 1268
control-vlan Configures the VLAN where meshpoint control traffic traverses page 1269
data-rates Configures the data rates supported per frequency band page 1269
description Configures a human friendly description for this meshpoint page 1273
meshid Configures a unique ID for this meshpoint page 1274
neighbor Configures the neighbor inactivity time out for this meshpoint page 1274
no Negates a command or reverts settings to their default page 1275
root Configures a meshpoint as the root meshpoint page 1278
security-mode Configures the security mode on the meshpoint. page 1279
service Allows only 802.11n capable neighbors to create a mesh connection page 1280
shutdown Shuts down the meshpoint page 1281
use Configures a QoS policy for use with this meshpoint page 1281
wpa2 Configures WPA2 encryption settings page 1282
clrscr Clears the display screen page 385
commit Commits (saves) changes made in the current session page 386
end Ends and exits the current mode and moves to the PRIV EXEC mode page 234