Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1068)

Brocade Mobility RFS Controller CLI Reference Guide 1059
53-1003098-01
17
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
nas <IP/M> secret [0|2|<LINE>]
nas <IP/M> secret [0 <LINE>|2 <LINE>|<LINE>]
Parameters
nas <IP/M> secret [0 <LINE>|2|<LINE>]
Example
rfs7000-37FABE(config-radius-server-policy-test)#nas 172.16.10.10/24 secret 0
wirelesswell
rfs7000-37FABE(config-radius-server-policy-test)#show context
radius-server-policy test
authentication eap-auth-type tls
crl-check
nas 172.16.10.10/24 secret 0 wirelesswell
local realm realm1
ldap-server primary host 172.16.10.19 port 162 login "motorolasol" bind-dn
"bind-dn1" base-dn "base-dn1" passwd 0 motorolasol@123 passwd-attr moto123
group-attr group1 group-filter "groupfilter1" group-membership
groupmembership1 net-timeout 2
ldap-server dead-period 100
rfs7000-37FABE(config-radius-server-policy-test)#
Related Commands:
no
radius-server-policy
Negates a command or reverts back to default settings. When used with in the config RADIUS
server policy mode, the
no
command removes settings, such as crl-check, LDAP group verification,
RADIUS client etc.
Supported in the following platforms:
<IP/M> Sets the RADIUS client’s IP address
•
<IP/M> – Sets the RADIUS client’s IP address in the A.B.C.D/M format
secret
[0 <LINE>|2 <LINE>|
<LINE>] Sets the RADIUS client’s shared secret. Use one of the following options:
•
0 <LINE> – Sets an UNENCRYPTED secret
•
2 <LINE> – Sets an ENCRYPTED secret
•
<LINE> – Defines the secret (client shared secret) up to 64 characters
no Removes a RADIUS server’s client on a RADIUS server policy