Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 419
404
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
5
service radius test [<IP>|<HOSTNAME>] <PORT> <1024-65535> <WORD> <USERNAME>
<PASSWORD> {wlan <WLAN-NAME> ssid <SSID>} {(on <DEVICE-NAME>)}
service set validation-mode [full|partial] {on <DEVICE-NAME>}
service show advanced-wips stats
[br-table|client-table|connected-sensors-status|
termination-entries]
service show block-adopter-config-update]
service show captive-portal [servers|user-cache] {on <DEVICE-NAME>}
radius test
Tests a RADIUS server’s account. This command sends an access-request packet to the RADIUS server. Use
this command to confirm time and data/bandwidth parameters for valid wireless clients.
•
test – Tests the RADIUS server’s account with user provided parameters
[<IP>|<HOSTNAME>]
Sets the IP address or hostname of the RADIUS server
•
<IP> – Specify the RADIUS server’s IP address.
•
<HOSTNAME> – Specify the RADIUS server’s hostname.
<PORT>
<1024-65535>
Specify the RADIUS server port from 1024 - 65535. The default port is 1812.
<WORD>
Specify the RADIUS server’s shared secret.
<USERNAME>
Specify username for authentication.
<PASSWORD>
Specify the password.
wlan <WLAN-NAME>
ssid <SSID>
Optional. Tests the RADIUS server on the local WLAN. Specify the local WLAN name.
•
ssid <SSID> – Specify the RADIUS server’s SSID.
on <DEVICE-NAME>
Optional. This is a recursive parameter also applicable to the WLAN parameter. Performs tests on a specified
device
•
<DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.
set
Sets the validation mode for running configuration validation
validation-mode
[full|partial]
Sets the validation mode
•
full – Performs a full configuration validation
•
partial – Performs a partial configuration validation
on <DEVICE-NAME>
Optional. Performs full or partial configuration validation on a specified device
•
<DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.
show
Displays running system statistics based on the parameters passed
advanced-wips stats
Displays advanced WIPS statistics
br-table
Displays AP table statistics
client-table
Displays client table statistics
connected-sensors-status
Displays connected sensor statistics
termination-entries
Displays termination entries statistics
show
Displays running system statistics based on the parameters passed
block-adopter-config-updat
e
Displays NOC configuration blocking status
show
Displays running system statistics based on the parameters passed
captive-portal
Displays captive portal information
servers
Displays server information for active captive portals