Failover – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual

Page 660

Advertising
background image

Brocade Mobility RFS Controller CLI Reference Guide

647

53-1003098-01

7

rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#show

co

ntext

gre tunnel testGRETunnel

dscp 20

rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#

The following example configures a GRE tunnel on a profile:

nx4500-5CFA2B(config-profile testNX45XX-gre-tunnel-testGRETunnel)#dscp 20

nx4500-5CFA2B(config-profile testNX45XX-gre-tunnel-testGRETunnel)#show

context

gre tunnel testGRETunnel

dscp 20

nx4500-5CFA2B(config-profile testNX45XX-gre-tunnel-testGRETunnel)#

Related Commands:

failover

gre-config-instance

Enables periodic pinging of the primary gateway to assess its availability. When enabled, the
system continues pinging, an unreachable gateway, for a specified number of times and at the
specified interval.

This option is disabled by default.

Supported in the following platforms:

Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point

Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000

Service Platforms — Brocade Mobility RFS9510

Syntax:

failover interval <0-86400> retry <0-10>

Parameters

failover interval <0-86400> retry <0-10>

Example

rfs4000-229D58(config-device

00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#failover interval 200 retry 5

no

Removes the GRE tunnel settings based on the parameters passed

failover interval <0-86400>
retry <0-10>

Specifies the interval, in seconds, between two successive pings to the primary gateway. If the primary
gateway is unreachable, the system pings it at intervals specified here.

<0-86400> – Specify a value from 0 - 86400 seconds.

retry – Specifies the maximum number attempts made to ping the primary gateway before the

session is terminated.

<0-10> – Specify a value from 0 - 10.

Advertising