Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 273)

Brocade Mobility RFS Controller CLI Reference Guide 257
53-1003098-01
4
NOTE
For more information on Meshpoint configuration, see Chapter 27, MESHPOINT
meshpoint-qos-policy
Global Configuration Commands
Configures a set of parameters that defines the meshpoint quality of service (QoS) policy
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
meshpoint-qos-policy <MESHPOINT-QOS-POLICY-NAME>
Parameters
meshpoint-qos-policy <MESHPOINT-QOS-POLICY-NAME>
Example
rfs7000-37FABE(config)#meshpoint-qos-policy TestMeshpointQoS
rfs7000-37FABE(config-meshpoint-qos-TestMeshpointQoS)#?
Mesh Point QoS Mode commands:
accelerated-multicast Configure accelerated multicast streams address and
forwarding QoS classification
no Negate a command or set its defaults
rate-limit Configure traffic rate-limiting parameters on a
per-meshpoint/per-neighbor basis
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-meshpoint-qos-TestMeshpointQoS)#
Related Commands:
<MESHPOINT-QOS-POLICY-
NAME> Specify the meshpoint QoS policy name. If the policy does not exist, it is created.
no Removes an existing meshpoint QoS policy