Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 950)

Brocade Mobility RFS Controller CLI Reference Guide 939
53-1003098-01
13
Example
rfs4000-229D58(config-dhcp-policy-test-pool-testPool)#address 192.168.13.4
class
dhcpclass1
rfs4000-229D58(config-dhcp-policy-test-pool-testPool)#show context
dhcp-pool testPool
address 192.168.13.4 class dhcpclass1
rfs4000-229D58(config-dhcp-policy-test-pool-testPool)#
Related Commands:
bootfile
dhcp-pool-mode commands
The Bootfile command provides a diskless node path to the image file while booting up. Only one
file can be configured for each DHCP pool.
For more information on the BOOTP protocol with reference to the DHCP policy, see bootp .
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
bootfile <IMAGE-FILE-PATH>
Parameters
bootfile <IMAGE-FILE-PATH>
range [<START-IP>|
<START-HOST-ALIAS-NAME>]
[<END-IP>|
<END-HOST-ALIAS-NAME>]
Adds a range of IP addresses to the DHCP address pool. Use one of the following options to provide
the first IP address in the range:
•
<START-IP> – Specifies the first IP address in the range
•
<START-HOST-ALIAS-NAME> – Specifies a host alias, mapped to the first IP address in the range
Use one of the following options to provide the last IP address in the range:
•
<END-IP> – Specifies the last IP address in the range
•
<END-HOST-ALIAS-NAME> – Specifies a host alias, mapped to the last IP address in the range
The host aliases should be existing and configured.
class
<DHCP-CLASS-NAME> Optional. Applies additional DHCP options, or a modified set of options to those available to wireless
clients. For more information, see
dhcp-class .
•
<DHCP-CLASS-NAME> – Sets the DHCP class.
no Removes the DHCP pool’s configured IP addresses
dhcp-class Creates and configures the DHCP class parameters
alias Creates and configures a network, VLAN, host, string, and network-service aliases
<IMAGE-FILE-PATH> Sets the path to the boot image for BOOTP clients. The file name can contain letters, numbers, dots and
hyphens. Consecutive dots and hyphens are not permitted.