Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1324)

1316 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
28
Specifies the EAP authentication mechanisms supported by each of the service providers
associated with this passpoint policy
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
eap-method <1-10>
[<1-255>|fast|gtc|identity|ikev2|ms-auth|mschapv2|otp|peap|psk|
rsa-public-key|sim|tls|ttls] auth-param
[credential|expanded-eap|expanded-inner-eap|
inner-eap|non-eap-inner|tunn-eap-credential|vendor]
Parameters
eap-method <1-10>
[<1-255>|fast|gtc|identity|ikev2|ms-auth|mschapv2|otp|peap|psk|
rsa-public-key|sim|tls|ttls] auth-param [credential|expanded-eap|
expanded-inner-eap|
inner-eap|non-eap-inner|tunn-eap-credential|vendor]
eap-method <1-10> Creates an EAP authentication method and assigns it an index number
•
<1-10> – Specify a identifier for this EAP method from 1 - 10.
A maximum of 10 (ten) authentication methods can be specified for every NAI realm. After creating the EAP
authentication method, specify the associated authentication mechanisms (method types).
<1-255> Identifies the EAP authentication method type from the corresponding Internet Assigned Numbers Authority
(IANA) number
<1-255> – Specify the IANA identity number for the authentication protocol from 1 -255.
fast Specifies the EAP authentication method type as Flexible Authentication via Secure Tunneling (FAST)
gtc Specifies the EAP authentication method type as Generic Token Card (GTC)
identity Specifies the EAP authentication method type as Identification
ikev2 Specifies the EAP authentication method type as Internet Key Exchange Protocol version 2 (IKEv2)
ms-auth Specifies the EAP authentication method type as Microsoft Authentication (MS-Auth)
mschapv2 Specifies the EAP authentication method type as Microsoft Challenge Handshake Authentication Protocol
version 2(MSCHAPv2)
opt Specifies the EAP authentication method type as One Time Password (OTP)
peap Specifies the EAP authentication method type as Protected Extensible Authentication Protocol (PEAP)
psk Specifies the EAP authentication method type as Pre-shared Key (PSK)
rsa-public-key Specifies the EAP authentication method type as RSA public key protocol
sim Specifies the EAP authentication method type as GSM Subscriber Identity Module (SIM)
tls Specifies the EAP authentication method type as Transport Layer Security (TLS)
ttls Specifies the EAP authentication method type as Tunneled Transport Layer Security (TTLS)
auth-param After specifying the EAP authentication method type, specify the authentication parameters. These
parameters depend on the EAP authentication mechanism selected.