Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 688)

Brocade Mobility RFS Controller CLI Reference Guide 675
53-1003098-01
7
switchport mode access
switchport access vlan 1
use ip-access-list in test
use mac-access-list in test
spanning-tree bpduguard enable
spanning-tree bpdufilter disable
spanning-tree force-version 1
spanning-tree guard root
spanning-tree mst 2 port-priority 10
dot1x supplicant username Bob password 0 motorolasolutions@123
ip dhcp trust
ip arp header-mismatch-validation
qos trust dscp
qos trust 802.1p
channel-group 1
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#
Related Commands:
interface-config-vlan-instance
interface
Use the config-profile-<DEVICE-PROFILE-NAME> mode to configure Ethernet, VLAN and tunnel
settings.
To switch to this mode, use the following commands:
<DEVICE>(config-profile-default-rfs7000<DEVICE-RPFILEPROFILE-NAME>)#interface
[<INTERFACE-NAME>|fe <1-4>|ge <1-8>|me1|port-channel <1-4>|pppoe1|radio
[1|2|3]|up1|vlan <1-4094>|wwan1|xge <1-24>]
The following example uses the config-profile-default-rfs7000 instance to configure a VLAN
interface:
rfs7000-37FABE(config-profile-default-rfs7000)#interface vlan 8
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#?
SVI configuration commands:
crypto Encryption module
description Vlan description
dhcp-relay-incoming Allow on-board DHCP server to respond to relayed DHCP
packets on this interface
ip Interface Internet Protocol config commands
no Negate a command or set its defaults
shutdown Shutdown the selected interface
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
no Disassociates the IP access list or MAC access list from the interface