Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1069)

1060 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
17
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no
[authentication|chase-referral|clr-check|ldap-agent|ldap-group-verification|
ldap-server|local|nas|proxy|session-resumption|use]
no authentication [data-source|eap]
no authentication [data-source {ldap {fallback}|local|ssid}|eap configuration]
no [chase-referral|clr-check|ldap-group-verification|nas
<IP/M>|session-resumption]
no ldap-agent [join-retry-timeout|primary|secondary]
no local realm [<REALM-NAME>|all]
no proxy [realm <REALM-NAME>|retry-count|retry-delay]
no ldap-server [dead-period|primary|secondary]
no use [radius-group [<RAD-GROUP-NAME>|all]|radius-user-pool-policy
[<RAD-USER-POOL-NAME>|all]]
Parameters
no authentication [data-source {ldap {fallback}|local}|eap configuration]
no [chase-referral|clr-check|ldap-group-verification|nas
<IP/M>|session-resumption]
no authentication Removes the RADIUS authentication settings
data-source
{ldap fallback|local}
{ssid <SSID>
precedence
<1-5000>} Removes configured data source
•
ldap fallback – Optional. Removes a remote LDAP server as the data source for user authentication
•
fallback – Optional. Disables fallback to local authentication in case LDAP authentication fails
•
local – Optional. Removes a local database as the source of user authentication
The following keywords are recursive and common to both ‘ldap’ and ‘local’ parameters:
•
ssid – Optional. Removes the SSID associated with this LDAP data source.
•
<SSID> – Specify the SSID.
•
precedence <SSID> – resets the precedence for this LDAP authentication rule.
•
<1-5000> – Specify the precedence from 1 -5000.
Use this option to configure different data sources for each SSID.
eap configuration Resets EAP authentication to the default mode
no chase-referral Disables LDAP server referral chasing
no crl-check Removes the CRL check
no ldap-group-verification Disables a RADIUS server’s LDAP group verification settings