Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 752)

Brocade Mobility RFS Controller CLI Reference Guide 739
53-1003098-01
7
Configures a password for this WWAN interface. The configured value is used for authentication
support by the cellular data carrier.
Supported in the following platforms:
• Access Points — Brocade Mobility 71XX Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000
Syntax:
password [2 <WORD>|<WORD>]
Parameters
password [2 <WORD>|<WORD>]
Example
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#password
TechPubsTesting@123
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#show
context
interface wwan1
password TechPubsTesting@123
crypto map test
ip nat inside
ip default-gateway priority 1
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#
Related Commands:
use
interface-config-wwan-instance
Associates an IP ACL with this interface. The ACL should be existing and configured.
The ACL applies an IP based firewall to all incoming packets. The ACL identifies a single IP or a
range of IPs that are to be allowed or denied access on this interface.
Supported in the following platforms:
• Access Points — Brocade Mobility 7131 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000
Syntax:
use ip-access-list in <ACCESS-LIST-NAME>
Parameters
2 <WORD> Configures an encrypted password. Use this option when copy pasting the password from another device.
<WORD> Enter the password string (should not exceed 32 characters in length.
no Removes the configured password