Rockwell Automation 900-TC32 Digital Temperature Controllers, Series B - Manual (Page 237)

Publication 900-UM007D-EN-E - January 2011
Parameter Functions & Definitions 5-9
Note: When a temperature input (e.g., RTD) is selected, the decimal point
position depends on the currently selected sensor, and when an analog
input is selected, it depends on the Decimal Point parameter setting.
Note: A 2-level display is set when shipped from the factory.
Note: A 3-level display is activated if parameters are initialized.
Note: When 1, 2, 5, or 6 is selected, press the
M
Key to display PV/SP
(Display 2).
EXAMPLE
When the PV/SP Display Screen Selection Parameter is Set to 2:
Related Parameter
• Input Type
• Set Point Upper Limit, Set Point Lower Limit (Initial Setting function
group, page 5-54)
• PV/SP Display Screen Selection (Advanced Setting function group,
page 5-8)
• PV (Process Value) (Advanced Setting function group, page 5-7)
5 PV/SP/Multi-SP and PV/SP/Soak time remain are displayed in
order.
6 PV/SP/MV and PV/SP/Soak time remain are displayed in order.
7 Only PV/SP/Soak time remain are displayed.
Table 5.K
Configured Value No. 3 Display Contents
25
100
50.0
25
100
sp0
M Press the
key.
Operation Level
PV/SP (Display 1)
PV/SP/MV PV/SP/Multi-SP
C C
PV/SP (Display 2)