Rockwell Automation 900-TC32 Digital Temperature Controllers, Series B - Manual (Page 337)

Publication 900-UM007D-EN-E - January 2011
Parameter Functions & Definitions 5-109
Function: This parameter resets the ON/OFF counter for specified control
outputs.
Note: After the counter has been reset, the count value will be automatically
returned to 0.
Related Parameter
• Control output 1 ON/OFF count monitor, Control output 2 ON/OFF
monitor (Advanced Setting function group, page 5-107)
Move to Calibration Group
Conditions of Use: Initial Setting/Communications Protect parameter must
be set to 0.
Function: This parameter allows you to configure the Password to Move to
the Calibration function group.
• Set the Password to Move to the Calibration function group. The
password is 1201.
• Move to the Calibration function group either by pressing the M
key or
the
O
key or by waiting for 2 seconds to elapse.
Related Parameter
• Initial Setting/Communications Protect (Protect function group, page
5-4)
Communications Setting
Function Group This function group allows you to configure the controller’s communication
parameters, enabling interface to a personal computer that is running the
controller configuration or monitoring software. The controller hardware must
support communications through a RS232 option module (900-TC8) or
RS485 option module (900-TC8, 900-TC16, and 900-TC32).
Table 5.EJ
Selections Default
0: Disable the counter reset function
0 1: Reset the control output 1 ON/OFF counter
2: Reset the control output 2 ON/OFF counter
cmov