Rockwell Automation 900-TC32 Digital Temperature Controllers, Series B - Manual (Page 277)

Publication 900-UM007D-EN-E - January 2011
Parameter Functions & Definitions 5-49
Figure 5.7
To move from the Operation function group to the Initial Setting function
group, press
key for 3 seconds with any parameter displayed except for
auto/man switch parameter.
• The Initial Setting function group is not displayed when the
Initial/Communications protection is set to 2. However, it can be used
when the Initial Setting/Communications Protection is set to 0 or 1.
• For 900-TC8 and 900-TC16: The Scaling Upper-Limit, Scaling
Lower-Limit, and Decimal Point parameters are displayed when an
analog input is selected as the Input Type.
Press the Key
for at least 3 seconds.
Control in Progress
Control Stopped
Operation
Function Group
Inital Setting
Function Group
25
100
\c Press the Key
for 1 second.