Rockwell Automation 900-TC32 Digital Temperature Controllers, Series B - Manual (Page 27)

Publication 900-UM007D-EN-E - January 2011
Bulletin 900 Input & Output Overview 1-3
Figure 1.3 — 900-TC32 I/O Configuration
Bulletin 900-TC8, 900-TC16, and 900-TC32 temperature controllers allow the
user to:
• Select from thermocouple and platinum RTD temperature sensors, plus
non-contact temperature sensor and analog voltage or current inputs. ➊
• Individually assign the function for each output by changing the
configured values of the following parameters: Control Output 1,
Assignment, Control Output 2 Assignment
➊ , Aux 1 Assignment, Aux 2
Assignment ➊ , and Aux 3 Assignment (900-TC8).
• Select heating and cooling control in addition to standard control
• Select AT (Auto-Tuning) and ST (Self-Tuning) as tuning functions
• Use multi-SP, switch between automatic and manual operation,
start/reset the simple program function, and initiate the RUN/STOP
function according to event input.
➊
• Use the Heater Burnout Alarm (HBA) and Heater Short Alarm (HSA)
function. ➊
• Use the communications function (for units equipped with the optional
communications function modules)
• Calibrate sensor input
• Configure the color of the PV display to switch between amber, red, and
green, making the process status easy to understand at a glance.
➊ The Bulletin 900-TC32 Temperature Controller does not support this function
Temperature
Input
Control
Output 1
Auxillary
Output 1
Control Output
(Cooling)
Alarm 1
Input Error
Program End
Output
Communications
Function
Control
Section
Heating/
Cooling
Standard
Control Output
(Heating)