Rockwell Automation 900-TC32 Digital Temperature Controllers, Series B - Manual (Page 73)

Publication 900-UM007D-EN-E - January 2011
Configuration & Basic Operation 3-3
How Function Groups Are
Configured and Operating
the Keys on the Front Panel Parameters are divided into control categories, each called a function group.
Each of the items/values that can be configured in these function groups is
called a parameter. The function groups on the Bulletin 900 controller are
divided into the following:
Figure 3.4 — Function Group Configuration
Note (1) You can return to the operation function group by executing a software reset.
(2) You cannot move to other function groups by operating the keys on the front panel
from the calibration function group. You must turn OFF the power supply.
(3) From the manual control function group, key operations can be used to move to the
operation function group only.
Start in manual mode.
25
100
c
25
100
c
a-m
Power ON
(See
note
3.)
(See
note 1.)
(See
note 2.)
Manual
mode
Press the Key or the
PF Key for at least 1 s.
(See note 4.)
Press the Key
for at least 3 s while
a-m is displayed.
( a-m will flash after
1st second.)
Operation
Function Group
Press the
Key for
at least 1 s.
Press the Key
for at least 1 s.
Input password.
Input password while
amoV is displayed. (Set
value − 169)
Press the
Key less than 1 s.
Press the Key for at
least 3 s. (Display will flash
after 1st second.)
Control stops.
Press the
Key for less than 1 s.
Press the
+
M
Keys for at
least 3 s.
(Display
will flash
after 1st
second.)
Protect Function Group
Control in progress
Function Group change
Not displayed for some models
Control stopped
Start in automatic mode.
Adjustment
Function Group
(See note 4.)
PF Key
(See note 5.)
PF Key
(See note 5.)
Initial Setting
Function Group
Manual Control
Function Group
Monitor/Setting
Item Function Group
Advanced Function
Setting Function Group
Calibration
Function Group
Press the PF Key
for at least 1 s.
Communica-
tions Setting
Function Group
Press the
+
M
Keys for at
least 1 s.
Note The time taken to move
to the protect function group can
be adjusted by chang-
ing the "Move to pro-
tect function group time" setting.
(4) When the PF Setting is configured to A-M in models with a PF Key (900-TC8)
(5) When the PF Setting is configured to PFDP in models with a PF Key (900-TC8)
O
O
O
O
O
O
O
O
O