Rockwell Automation 900-TC32 Digital Temperature Controllers, Series B - Manual (Page 287)

Publication 900-UM007D-EN-E - January 2011
Parameter Functions & Definitions 5-59
Alarm Type for Alarm 1
Conditions of Use: Alarm 1 must be configured and supported by the
controller.
Function: This parameter allows you to configure the type of alarm operation
for Alarm Output 1. Select one of the following Alarm 1 types:
Deviation, Deviation range, Absolute value, LBA, or PV change rate
alarm.
Note: Refer to Table 5.BR for details.
Related Parameters
• Alarm value 1 (page 5-16); Alarm value upper limit 1, Alarm value lower
limit 1(page 5-18 (Operation function group)
• Standby sequence reset (page 5-72); Auxiliary output 1 open in alarm
(page 5-73); Alarm 1 latch (page 5-79) (Advanced Setting function
group); Alarm 1 hysteresis (Initial Setting function Group, page 5-61)
Alarm Type for Alarm 2 (900-TC8 & 900-TC16)
Alarm Type for Alarm 3 (900-TC8)
Conditions of Use: Alarm 2 and 3 must be configured and supported by the
controller hardware.
Function: These parameters allow you to configure the type of alarm
operation for Alarm Output 2 and Alarm Output 3.
• For Alarm 2 and 3, you can select Alarm types: Deviation, Deviation
range, Absolute Value, or PV change rate alarm (Note: cannot use
LBA).
alt1
alt2
alt3