Rockwell Automation 900-TC32 Digital Temperature Controllers, Series B - Manual (Page 249)

Publication 900-UM007D-EN-E - January 2011
Parameter Functions & Definitions 5-21
Related Parameters
• Input Type (page 5-50), Scaling Upper-Limit, Scaling Lower-Limit,
Decimal Point (page 5-52), Alarm 3 Type (page 5-59) (Initial Setting
function group)
• Standby Sequence Reset (page 5-72), Auxiliary Output 3 Open in Alarm
(page 5-73), Alarm 3 Hysteresis (page 5-62), Alarm 3 Latch (page 5-79)
(Advanced Setting function group)
MV Monitor (Heating)
Conditions of Use: The Manipulated Variable (MV) display parameter must
be set to ON.
Function: This parameter allows you to monitor the Manipulated Variable
(for the heating Control Output).
Table 5.Y
• This parameter cannot be configured.
• During standard control, the manipulated variable is monitored. During
heating/cooling control, the manipulated variables on the heating
Control Output is monitored.
Note: The default of the Manipulated Variable Display parameter is OFF and
the manipulated variable is not displayed.
Related Parameter
• Manipulated Variable Display (Advanced Setting function group, page
5-78)
Control Mode Monitoring Range Units
Standard –5.0…105.0 %
Heating and cooling 0.0…105.0 %
o