Rockwell Automation 900-TC32 Digital Temperature Controllers, Series B - Manual (Page 251)

Publication 900-UM007D-EN-E - January 2011
Parameter Functions & Definitions 5-23
To move to the Adjustment function group from the Operation function
group, press the
key for less than 1 second.
1. Adjustment function group parameters can be changed after
configuring the Operation/Adjustment Protect parameter to 0. Displays
and moving to other function groups is not possible if the
Operation/Adjustment Protect parameter is set from 1 to 3. Protection
is set in the Protect function group.
2. The Set Point Parameters 0 to 3 in the Adjustment function group are
the configured values for switching the set point during multi-SP input.
3. For 900-TC8 and 900-TC16: The following parameters are displayed
for Controllers with CT Inputs: Heater Current 1 to 3 monitor, Leakage
Current 1 to 3 monitor, Heater Burnout detections 1 to 3, HS Alarms 1
to 3, and Heater Overcurrent detection 1 to 3.