Rockwell Automation 900-TC32 Digital Temperature Controllers, Series B - Manual (Page 244)

Publication 900-UM007D-EN-E - January 2011
5-16 Parameter Functions & Definitions
Function: This parameter measures and displays the soak time remaining for
the simple program function.
Related Parameters
• Program Start (Operation function group, page 5-15)
• Soak Time, Wait Band (Adjustment function group, page 5-40)
• Program Pattern (Initial Setting function group, page 5-57)
• Soak Time Unit (Advanced Setting function group, page 5-96)
RUN/STOP
Conditions of Use: The Event Input Assignments 1 and 2 parameter must
NOT be configured to RUN/STOP.
Function: This parameter allows you to change and monitor the operational
RUN/STOP mode of the controller.
When
run
: is selected, the controller is running. When
stop
: is selected, the
controller is stopped. When the controller is stopped, the STOP LED display
lights.
When the RUN/STOP function is being controlled by an event input, the
RUN/STOP function cannot be initiated by operating the keys on the
controller front panel, and the parameter will NOT be displayed in the
Operation function group.
Note: The default is
run
.
Alarm Value 1
Conditions of Use: Alarm 1 must be assigned. The alarm 1 type must not be
0, 1, 4, 5, or 12.
Table 5.R
Monitoring Range Units
0…9999 Minutes or hours
r-s
al-1