Agilent Technologies Signal Analyzer N9030a - Manual (Page 1218)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Sweep/Control
Preset 0 s
State Saved Saved in instrument state
Min –10.000 s
Max 10.000 s
Default Unit S
Initial S/W Revision Prior to A.02.00
Reset Offset Display
Resets the value of the periodic trigger offset display setting to 0.0 seconds. The current displayed
trigger location may include an offset value defined with the Offset key. Pressing this key redefines
the currently displayed trigger location as the new trigger point that is 0.0 s offset. The Offset key
can then be used to add offset relative to this new timing.
Key Path Trigger, Periodic Timer
Remote Command :TRIGger[:SEQuence]:FRAMe:OFFSet:DISPlay:RESet
Example TRIG:FRAM:OFFS:DISP:RES
Initial S/W Revision Prior to A.02.00
Sync Source
Selects a signal source for you to synchronize your periodic timer trigger to, otherwise you are
triggering at some arbitrary location in the frame. Synchronization reduces the precision
requirements on the setting of the period.
For convenience you may adjust the level and slope of the selected sync source in a conditional
branch setup menu accessed from the Sync Source menu. Note that these settings match those in
the Trigger and Gate Source menus; that is, each trigger source has only one value of level and
slope, regardless of which menu it is accessed from.
Key Path Trigger, Periodic Timer
Remote Command :TRIGger[:SEQuence]:FRAMe:SYNC EXTernal1 | EXTernal2 | RFBurst | OFF
:TRIGger[:SEQuence]:FRAMe:SYNC?
Example TRIG:FRAM:SYNC EXT2
Dependencies In some models, there is no second External input. In these models, the External 2 key is
blanked and the EXTernal2 parameter will generate a “Hardware missing; Not available for this
model number” message.
1218 Remote Language Compatibility Measurement Application Reference