Agilent Technologies Signal Analyzer N9030a - Manual (Page 1254)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
System
TDSCDMA | VSA | VSA89601 | WCDMA | WIMAXOFDMA
:SYSTem:PON:MODE?
Example SYST:PON:MODE SA
Notes The list of possible modes (and remote parameters) to choose from is dependent on which modes
are installed in the instrument.
Preset This is unaffected by a Preset but is set on a “Restore System Defaults->All” to SA.
State Saved No
Initial S/W Revision Prior to A.02.00
Configure Applications
The Configure Applications utility can be used to:
•
select applications for preload
•
determine how many applications can fit in memory at one time
•
specify the order of the Modes in the Mode menu.
This utility consists of a window with instructions, a set of “Select Application” checkboxes, a
“fuel bar” style memory gauge, and keys that help you set up your configuration.
For more information, see the following topics:
"Preloading Applications" on page 1254
"Access to Configure Applications utility" on page 1255
"Virtual memory usage" on page 1255
Key Path System, Power On
Example :SYST:SHOW CAPP Displays the Config Applications screen
Initial S/W Revision A.02.00
Preloading Applications
During runtime, if a Mode that is not preloaded is selected using the Mode menu or sending SCPI
commands, there will be a pause while the Application is loaded. During this pause a message
that says “Loading application, please wait …” is displayed. Once loaded, the application stays
loaded, so the next time you select it during a session, there is no delay.
1254 Remote Language Compatibility Measurement Application Reference