Agilent Technologies Signal Analyzer N9030a - Manual (Page 207)

5 Legacy Command Descriptions
Command Syntax
Syntax
Component
Definition/Range
Analyzer
command Any command in this chapter, with required parameters and terminators.
Character SP a b c d e f g h i j k l m n o p q r s t u v w x y z databyte.
Character
& EOI 8-bit byte containing only character data and followed by end-or-identify (EOI) condition, where the EOI control
line on GPIB is asserted to indicate the end of the transmission. END signifies the EOI condition.
Character
string A list of characters.
Data byte 8-bit byte containing numeric or character data.
Data byte &
EOI 8-bit byte containing numeric or character data followed by end-or-identify (EOI) condition, where the EOI
control line on GPIB is asserted to indicate the end of the transmission. END signifies the EOI condition.
Delimiter | \ @ ˆ $ % ; ! Matching characters that mark the beginning and end of a character string, or a list of
commands. Choose delimiting characters that are not used within the string they delimit.
Digit 0 1 2 3 4 5 6 7 8 9
lsb length Represents the least significant byte of a two-byte word that describes the number of bytes returned or
transmitted. See msb length.
msb length Represents the most significant byte of a two-byte word that describes the number of bytes returned or
transmitted. See lsb length.
Number Expressed as integer, decimal, or in exponential (E) form.
Integer Number Range: –32,768 through +32,767
General formatting restrictions:
Real Number Range: ± 1.797693134862315 x 10
308
, including 0.
Up to 15 significant figures allowed.
Numbers may be as small as ± 2.225073858507202 x 10
–308
Output
termination Line feed (LF) and end-or-identify (EOI) condition. ASCII code 10 (line feed) is sent via GPIB and the end-or-
identify control line on GPIB sets to indicate the end of the transmission.
Units Represent standard scientific units:
Frequency Units: GZ, GHZ, MZ, MHZ, KZ, KHZ, HZ
Amplitude Units: DB, DBMV, DM, DBM, DBUV, V, MV, UV, W, MW, UW
Time Units: SC, S, MS, US
Syntax Elements
Remote Language Compatibility Measurement Application Reference 207