Agilent Technologies Signal Analyzer N9030a - Manual (Page 203)

4 List of Legacy Analyzer Commands
Alphanumeric List of all Legacy Commands with N9061A Support
Command Description 8566 8568
8560
Series Description
TOIR Third order intermodulation
response N/A N/A N/A
TRA Returns trace A amplitude
values to controller Yes Yes Yes "TRA (Trace Data Input and Output)" on page
491
TRB Returns trace B amplitude
values to controller Yes Yes Yes "TRB (Trace Data Input and Output)" on page
492
TRC Returns trace C amplitude
values to controller Yes Yes N/A "TRC (Trace Data Input and Output)" on page
493
TRCMEM Trace C memory N/A N/A N/A
TRDEF Trace define No No No
TRDSP Trace display Yes Yes N/A "TRDSP (Trace Display)" on page 494
TRGRPH Trace graph display No No N/A
TRIGPOL Trigger polarity N/A N/A Yes "TRIGPOL (Trigger Polarity)" on page 495
TRMATH Executes specified trace
math at end of sweep No No N/A
TRPRST Sets trace operations to
their preset values No No N/A
TRSTAT Returns current trace
states to controller Yes Yes N/A "TRSTAT (Trace State)" on page 496
TS Takes a sweep Yes Yes Yes "TS (Take Sweep)" on page 497
TVLINE Selects which horizontal
line of video to trigger on N/A N/A N/A
TVLSFRM Selects the type of video
frame to trigger on N/A N/A N/A
TVSTND TV standard N/A N/A N/A
TVSYNC Selects polarity of video
modulation to trigger on N/A N/A N/A
TWNDOW Formats trace information
for FFT. N/A N/A No
UNTIL Conditional Programming
(Repeat…Until…) No No No
UP Increases active function
value by applicable step N/A N/A N/A
UR Upper right x-y recorder
output voltage at rear No No N/A
Remote Language Compatibility Measurement Application Reference 203