Agilent Technologies Signal Analyzer N9030a - Manual (Page 154)

3 Programming the Analyzer
STATus Subsystem
Questionable Calibration Extended Failure Positive Transition
This command determines which bits in the Questionable Calibration Extended Failure Condition
register will set the corresponding bit in the Questionable Calibration Extended Failure Event
register when the condition register bit has a positive transition (0 to 1). The variable <integer> is
the sum of the decimal values of the bits that you want to enable.
Mode All
Remote
Command :STATus:QUEStionable:CALibration:EXTended:FAILure:PTRansition <integer>
:STATus:QUEStionable:CALibration:EXTended:FAILure:PTRansition?
Example STAT:QUES:CAL:EXT:FAIL:PTR 1
EMI conducted align failure is required.
Preset 32767
Min 0
Max 32767
Status Bits/OPC
dependencies Sequential command
Initial S/W
Revision Prior to A.02.00
Questionable Calibration Extended Needed Register
The following commands and queries are available for this register:
"Questionable Calibration Extended Needed Condition" on page 154
"Questionable Calibration Extended Needed Enable" on page 155
"Questionable Calibration Extended Needed Event Query" on page 155
"Questionable Calibration Extended Needed Negative Transition" on page 156
"Questionable Calibration Extended Needed Positive Transition" on page 156
Questionable Calibration Extended Needed Condition
This query returns the decimal value of the sum of the bits in the Questionable Calibration
Extended Needed Condition register.
The data in this register is continuously updated and reflects the current conditions.
Mode All
154 Remote Language Compatibility Measurement Application Reference