Agilent Technologies Signal Analyzer N9030a - Manual (Page 141)

3 Programming the Analyzer
STATus Subsystem
"Operation Event Query" on page 142
"Operation Negative Transition" on page 142
"Operation Positive Transition" on page 143
Operation Condition Query
This query returns the decimal value of the sum of the bits in the Status Operation Condition
register.
The data in this register is continuously updated and reflects the current conditions.
Mode All
Remote Command :STATus:OPERation:CONDition?
Example STAT:OPER:COND?
Preset 0
Status Bits/OPC dependencies Sequential command
Initial S/W Revision Prior to A.02.00
Operation Enable
This command determines which bits in the Operation Event register, will set the Operation
Status Summary bit (bit 7) in the Status Byte Register. The variable <integer> is the sum of the
decimal values of the bits you want to enable.
The preset condition is to have all bits in this enable register set to 0. To have any Operation Events
reported to the Status Byte Register, one or more bits need to be set to 1.
Mode All
Remote Command :STATus:OPERation:ENABle <integer>
:STATus:OPERation:ENABle?
Example STAT:OPER:ENAB 1 Sets the register so that Align Now operation will be reported to the Status
Byte Register.
Preset 0
Min 0
Max 32767
Status Bits/OPC Sequential command
Remote Language Compatibility Measurement Application Reference 141