Agilent Technologies Signal Analyzer N9030a - Manual (Page 828)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Meas Setup
Example :CALC:LIM:FAIL?
returns a zero if limit line 1’s associated trace has no failure, 1 if there is a margin or limit failure.
Couplings This command is identical to :CALC:LLIN:FAIL?
Initial S/W Revision A.02.00
Limit Clear (Remote Command Only, SCPI standard conformance)
Clears a limit line, and all associated data. This command is identical to “:CALC:LLIN:DEL”
Remote Command :CALCulate:LIMit[1]|2|...6:CLEar
Example :CALC:LIM2:CLE
deletes all data for limit line 2.
Couplings This command is identical to :CALC:LLIN:DEL
Initial S/W Revision A.02.00
Trace Fail? (Remote Command Only)
Tests a trace against all associated limit lines. Returns a 0 if the trace is within all limits and
margins, a 1 if the trace exceed either the limit or the margin. If no limits apply to the selected
trace, this will automatically return a 0.
Only applies to limits that are turned on, if a Limit is off it will not be tested. If a Trace is not
displaying it will still be tested, and if Test Limits (All Limits) is off the Trace will still be tested.
This command ignores limit lines that are assigned to other traces.
Remote Command :CALCulate:TRACe[1]|2|...6:FAIL?
Example :CALC:TRAC3:FAIL?
returns a zero if there is no failure, 1 if the trace exceeds either the limit or the margin.
Initial S/W Revision A.02.00
Fixed / Relative Limit (Remote Command Only)
This command sets both Relative to CF and Relative to RL simultaneously for all limits. If
queried, it returns whether Limit Line 1 is set Relative to CF, and ignores all other fixed/relative
data.
Remote Command :CALCulate:LLINe:CMODe FIXed|RELative
828 Remote Language Compatibility Measurement Application Reference