Agilent Technologies Signal Analyzer N9030a - Manual (Page 913)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Quick Save
One of the key features of Auto File Name is that we guarantee that the Auto File Name will never
conflict with an existing file.The algorithm looks for the next available number. If it gets to 9999,
then it looks for holes. If it find no holes, that is no more numbers are available, it gives an error.
For example, if when we get to State_0010.state there is already a State_0010.state file in the
current directory, it advances the counter to State_0011.state to ensure that no conflict will exist
(and then it verifies that State_0011.state also does not exist in the current directory and
advances again if it does, and so forth).
If you enter a file name for a given file type, then the prefix becomes the filename you entered
instead of the default prefix, followed by an underscore. The last four letters (the suffix) are the 4-
digit number.
For example, if you save a measurement results file as “fred.csv”, then the next auto file name
chosen for a measurement results save will be fred_0000.csv.
Although 0000 is used in the example above, the number that is used is actually the current number in the
Meas Results sequence, that is, the number that would have been used if you had not entered your own
file name.
.
If the filename you entered ends with _dddd, where d=any number, making it look just like an auto file
name, then the next auto file name picks up where you left off, with the suffix being dddd + 1.
Key Path Front-panel key
Notes No remote command for this key specifically.
Initial S/W Revision Prior to A.02.00
Remote Language Compatibility Measurement Application Reference 913