Agilent Technologies Signal Analyzer N9030a - Manual (Page 188)

4 List of Legacy Analyzer Commands
Alphanumeric List of all Legacy Commands with N9061A Support
Command Description 8566 8568
8560
Series Description
KSC Sets amplitude units to
dBuV Yes Yes N/A "KSC (Amplitude in dBμV)" on page 324
KSc Trace A + trace B -> trace
A Yes Yes N/A "KSc (A Plus B to A)" on page 325
KSD Sets amplitude units to V Yes Yes N/A "KSD (Amplitude in Volts)" on page 326
KSd Selects negative peak
detection Yes Yes N/A "KSd (Negative Peak Detection)" on page 327
KSE Sets the analyzer title
mode Yes Yes N/A "KSE (Title Mode)" on page 328
KSe Selects sample detection Yes Yes N/A "KSe (Sample Detection)" on page 329
KSF HP8566: Shifts the YTO
HP8568: Measures the
Sweep Time No No N/A
KSf Recover last instrument
state at power on No No N/A
KSG Turns on video averaging Yes Yes N/A "KSG (Video Averaging On)" on page 330
KSg Turns off the display Yes Yes N/A "KSg (Display Off)" on page 331
KSH Turns off video averaging Yes Yes N/A "KSH (Video Averaging Off)" on page 332
KSh Turns on the display Yes Yes N/A "KSh (Display On)" on page 333
KSI Allows the reference level
to be extended No No N/A
KSi Exchanges traces B & C Yes Yes N/A "KSi (Exchange Trace B and Trace C)" on
page 334
KSJ Manual control of DACs No No N/A
KSj Views trace C Yes Yes N/A "KSj (View Trace C)" on page 335
KSK HP8566: Active Mkr to next
highest peak
HP8568: Counts pilot IF at
marker Yes No N/A "KSK (Marker to Next Peak)" on page 336
KSk Blanks trace C Yes Yes N/A "KSk (Blank Trace C)" on page 337
KSL Turns off marker noise
function Yes Yes N/A "KSL (Marker Noise Off)" on page 338
KSl Moves trace B into trace C Yes Yes N/A "KSl (Transfer Trace B to Trace C)" on page
339
KSM Turns on marker noise Yes Yes N/A "KSM (Marker Noise On)" on page 340
188 Remote Language Compatibility Measurement Application Reference