Agilent Technologies Signal Analyzer N9030a - Manual (Page 159)

3 Programming the Analyzer
STATus Subsystem
has a negative transition (1 to 0). The variable <integer> is the sum of the decimal values of the
bits that you want to enable.
Mode All
Remote
Command :STATus:QUEStionable:FREQuency:NTRansition <integer>
:STATus:QUEStionable:FREQuency:NTRansition?
Example STAT:QUES:FREQ:NTR 2
Frequency Reference ‘regained lock’ will be reported to the Frequency Summary of the Status Questionable
register.
Preset 0
Min 0
Max 32767
Status
Bits/OPC
dependencies Sequential command
Initial S/W
Revision Prior to A.02.00
Questionable Frequency Positive Transition
This command determines which bits in the Questionable Frequency Condition register will set
the corresponding bit in the Questionable Frequency Event register when the condition register bit
has a positive transition (0 to 1). The variable <integer> is the sum of the decimal values of the
bits that you want to enable.
Mode All
Remote
Command :STATus:QUEStionable:FREQuency:PTRansition <integer>
:STATus:QUEStionable:FREQuency:PTRansition?
Example STAT:QUES:FREQ:PTR 2
Frequency Reference ‘became unlocked’ will be reported to the Frequency Summary of the Status
Questionable register.
Preset 32767
Min 0
Max 32767
Status
Bits/OPC
dependencies Sequential command
Initial S/W
Revision Prior to A.02.00
Remote Language Compatibility Measurement Application Reference 159