Agilent Technologies Signal Analyzer N9030a User Manual

Page 1223

Advertising
background image

6  RLC Swept SA Measurement Front-Panel & SCPI Reference

Sweep/Control

Preset

POSitive

State Saved

Saved in instrument state

Backwards
Compatibility SCPI

:TRIGger[:SEQuence]:FRAMe:EXTernal2:SLOPe

Backwards Compatibility
Notes

The legacy :TRIGger[:SEQuence]:SLOPe command affects the slopes for the VID, LINE, EXT1,
EXT2, and RFB triggers.

Initial S/W Revision

Prior to A.02.00

RF Burst

Pressing this key, when it is not selected, selects the RF Burst as the trigger. A new
sweep/measurement will start when an RF burst envelope signal is identified from the signal at
the RF Input connector. Pressing this key, when it is already selected, accesses the RF Burst
trigger setup menu.

In some models, a variety of burst trigger circuitry is available, resulting in various available
burst trigger bandwidths.  The analyzer automatically chooses the appropriate trigger path based
on the hardware configuration and other settings of the analyzer.

Key Path

Trigger

Example

TRIG:SOUR RFB                 Swept SA measurement

TRIG:<meas>:SOUR RFB   Measurements other than Swept SA

State Saved

Saved in instrument state

Status Bits/OPC
dependencies

The Status Operation Register bit 5 "Waiting for Trigger" is set at the same time as the Sweeping
or Measuring bit is set. It is cleared when the trigger actually occurs (that is, after the trigger
event occurs and all the applicable trigger criteria have been met). A corresponding pop-up
message ("Waiting for trigger") is generated if no trigger signal appears after approximately 2
sec. This message goes away when a trigger signal appears.

Backwards Compatibility
Notes

The legacy command:

:TRIGger[:SEQuence]:RFBurst:FSELectivity[:STATe] OFF|ON|0|1

is not supported in the X-Series, as the hardware to do Frequency Selective burst triggers does
not exist in X-Series.

Initial S/W Revision

Prior to A.02.00

Modified at S/W
Revision

A.04.00

Remote Language Compatibility Measurement Application Reference

1223

Advertising